Protectosil® 100

Protectosil® 100 is a free-flowing, colorless, frost resistant, solvent-free liquid based on a monomeric silane.

Scope of Application

The substrates to be treated should be air-dry and clean in order to ensure deep penetration of the active ingredient. During application the outside temperature and the temperature of the substrate should be within the range from 0 °C to 45 °C. The material should not be applied if there is strong wind or if it is raining. The material must not come into contact with water either before or during use. Protectosil® 100 must be applied by flowcoating to the saturation point. This is achieved by allowing it to flow without pressure against the surface to be treated. All liquid delivery devices are suitable (airless sprayguns, for example). The material must not be atomized or applied with a brush. Protectosil® 100 must remain in contact with the substrate for several seconds as a liquid film. Horizontal surfaces should have a shiny, wet appearance for 3-5 seconds. Vertical surfaces should exhibit a 30-50 cm shiny curtain of liquid. All equipment and containers must be clean and dry. After use they can be cleaned with any organic solvent (methylated spirit, petrol or thinners). Non-absorbent substrates such as glass, wood, plastic, and metal cannot be treated with Protectosil® 100. In the worst case, product not absorbed by the substrate may react with atmospheric moisture to form a greasy, glossy silicone resin film. Substrates such as those mentioned above should therefore be covered before the application. If they nevertheless become contaminated, the resulting film can be easily removed if cleaned immediately using conventional cleaning agents, or alcohol (spirit of soap) in difficult cases. Glass, wood and metal are not attacked by Protectosil® 100. Neither are most plastics used in construction. If in doubt, carry out a preliminary test. Plants in the vicinity of the substrate to be treated should be protected against contact with Protectosil® 100.